This tool will help you to generate the "STRING" needed for the options field in your hotspot. e.g Static Talkgroups and Configurations in Pi-Star / MMDVM / DMRGateway.

Duplex Hotspots / Repeaters can use TS1 and/or TS2

Simplex Hotspots can only use TS2

Type in the Talk Groups and Settings you want.
Click "Generate Pi-Star Options"

Duplex: Simplex:


 Maximum of 6 Digits per TG Numbers

Timeslot 1
Timeslot 2
  TG 1 (leave 0 for none):   TG 1 (leave 0 for none):
  TG 2 (leave 0 for none):   TG 2 (leave 0 for none):
  TG 3 (leave 0 for none):   TG 3 (leave 0 for none):
  TG 4 (leave 0 for none):   TG 4 (leave 0 for none):
  TG 5 (leave 0 for none):   TG 5 (leave 0 for none):
  TG 6 (leave 0 for none):   TG 6 (leave 0 for none):
  TG 7 (leave 0 for none):   TG 7 (leave 0 for none):
  TG 8 (leave 0 for none):   TG 8 (leave 0 for none):
  TG 9 (leave 0 for none):   TG 9 (leave 0 for none):


  Dial-a-TG  0 or 2350
  Voice Identification    0 or 1
  Language  0 or en_GB  
  Single Mode  0 or 1
  TG Timeout  Minutes




( Copy & paste the "string" when generated above into the "Options= field" in your device. )


Explanation.

Information.

Options=TS1=2061,206;TS2=20600;DIAL=0;TIMER=10;VOICE=0;SINGLE=0;LANG=0;


TS1=2061,206;

Set Statics you want on Slot 1.  Separate each Talk Group with a comma.
At the end of each section you need a Semicolon.


TS2=20600,20604;

Set Statics you want on Slot 2.  Separate each Talk Group with a comma.
At the end of each section you need a Semicolon.


DIAL=20600;

0=None. Set default Enhanced Talk Groups (Dial-a-TG) TG9 Slot 2.
Only One Talk Group can be entered in this section.
You should not have the same Talk Group set as static on Slot 1 or Slot 2.
At the end of each section you need a Semicolon.

TIMER=10;

Time a Talk Group is held active for.  Pressing your PTT on a Talk Group reset this timer.
You select any number of minutes you like here.  But the recommended time is 10 or 5 mins.
If setting more than two static to a slot, you might wish to set Timer to  1 or 2 min.
At the end of each section you need a Semicolon.


VOICE=0;

0=OFF  1=ON.  15 minute Voice Ident can be set ON or OFF on Time Slot 2.
Radios will RX from the network "This is CALL-SIGN FreeDMR. "
At the end of each section you need a Semicolon.


SINGLE=0;

Turn off Single Mode. Network default is ON=0. OFF=1.
At the end of each section you need a Semicolon.


LANG=0;

Set the Language the VOICE comes back to you as.  0=Servers Default.
At the end of each section you need a Semicolon.


Each section is separated with a Semicolon. "Does not matter what order the above codes are in".